Monthly Archives: June 2020

  • 0

How to do Swimming Pool Tile Cleaning With Household Items

Tags : 

A dirty swimming pool can ruin the purpose of your pool. It is very difficult to relax and swim in a pool with stained and dirty tiles. It’s an eyesore and will make you feel dirty after swimming in the pool like you just stepped out of floodwaters.

It is not supposed to be that way. So in this article, we will show you how you can easily clean your pool tiles with everyday household materials. You can do this on a calm Saturday morning and be done in a couple of hours.

So, get your rubber gloves ready. This may impress you better than you imagine it could.

Let’s Begin

For cleaning your tile joints, mix 1/3 liter of dishwashing liquid in a liter of hot water. Rub vigorously and rinse.

Besides commercially available household cleaning products, there are several natural and affordable solutions to whiten your tile joints.

Bathroom, kitchen… Over time, grease residues, mold, and yellow stains can appear on the tile joints. To overcome this dirt and restore its shine to your joints without getting tired, there are natural tips to test without hesitation.

How to clean the tile joints?

Before cleaning the joints, first, wash the tiles around them. If they are dirty, the seals will be too. Then, to clean the tile joints you can recycle an old toothbrush which you will use as a joint brush. On the product side, you have many possibilities: white vinegar works miracles in the house, claystone, and Meudon white are very effective at cleaning joints. Black soap cleans thoroughly.

To use these natural products, soak a sponge of warm water and do not hesitate to scrub the dirtiest parts well.

What products should I avoid when cleaning tile joints?

To properly clean the tile joints, avoid using a steam cleaner repeatedly. This could take off the tiles. In the same way, forget about bleach and acid, these products toxic to health and the environment, wear out the seals, and can damage the seal. Water could then infiltrate and cause the tiles to peel off.

Which product should you use to whiten tile joints?

Weather and humidity damage the tile joints, which will then be stained and blackened. This is quite unsightly and gives the impression that the tiles are dirty and old. To whiten the joints, a miracle and natural product can be used: baking soda! Add with white vinegar and washing up liquid, the baking soda will allow you to whiten the tile joints naturally. Let this mixture sit for a few minutes on the joints before rubbing with a brush. They will then be white as on the first day!

These are simple tips you can start implementing today and see impressive results on your pool tiles. If you don’t have the time to do this yourself and will love a professional to step in with industry-standard materials to give you a perfect swimming pool tile cleaning job, contact us. We will love to help you bring your pool back to its former glory, looking good as new.


  • 0
Calcium Cleaning Specialties Aquatic Tile Cleaning

Soft White Deposits vs Hardened Calcium Deposits: How to Clean Them

Tags : 

Lime stains, sometimes called scale, occur around the upper edge of the pool and resemble deposits of white or gray crusts. They are often caused by hard water or minerals that seep from nearby mortar glue. 

If left in place, they can lead to permanent stains on the tile, as well as causing the pool to look dirty and unattractive. Removal of calcium deposits from tiles in the pool will require some physical work.

Although efflorescence is not harmful to cement, excessive amounts of it can cause fungal or insect problems. Once the calcium deposits harden, they are virtually impossible to remove without acid solutions.

Sometimes they could be soft white scales and in severe cases, thicker and harder. You’ll have to approach cleaning them with different strategies.

Natural stone and glass tile combo

Unfortunately, you must repeat the process periodically, as the spots often return.

How to Clean the Soft White Scales on Your Tiles

  1. Drain the water from the pool at least 6 to 10 inches so you can easily access areas stained with calcium. This also allows you to clean the loosened calcium off without depositing it in the pool water.
  2. Kneel on the edge of the pool, or enter the pool if you do not mind getting wet. Place a stiff brush bristle tiles on top of the calcium deposits and scrub the tiles of the pool using circular motions to loosen the deposits.
  3. Clean the tile of the pool with a cloth or a paper towel to remove the loosened calcium. Examine the area to see if all the deposit came off, and use a pumice stone to scrub gently with circular motions or no calcium is maintained.
  4. Remove the thickness scale from the tile with a razor blade, taking care to keep a low angle and avoid scratching the surface.
  5. Clean the area again with the cloth. Repeat the process to clean around the perimeter of the pool to remove the remaining calcium deposits.

Tips and warnings

  • You can use a standard pumice stone available at beauty stores or buy one at a pool store that has a longer handle made specifically for pools.
  • Commercial products are also available to remove tile incrustations from the pool.

How to Remove the Heavy Concrete Calcium Deposits

Stronger acids are required for the heavier calcium deposits.

Instructions

  1. Dress appropriately for security purposes. Wear protective clothing, goggles, acid-resistant gloves, and a mask equipped with an acid-grade filter.
  2. Set a portable fan nearby and open the windows to provide adequate air circulation. Fill a spray bottle with acetic acid.
  3. Spray the acetic acid generously on the calcium deposits. Allow the acid to penetrate the cement for the recommended amount of time. Follow the manufacturer’s instructions on the product label.
  4. Scrub the cement with a hard bristle brush to dissolve the calcium deposits. Continue to apply acetic acid and scrub the cement until all calcium deposits are removed.
  5. Sprinkle baking soda generously over clean cement to neutralize the acid. While the acid neutralizes, fill a plastic bucket with water.6 Clean the affected surfaces promptly to restore the appearance of the cement and prevent future problems. To do this, cement thoroughly rinsed with water, using a coarse sponge. Allow the cement to air dry.

Tips and warnings

  • You can substitute hydrochloric acid for acetic acid. However, never use hydrochloric acid inside or mix it with any chemical.
  • Be very careful when using acetic acid; It is highly corrosive to the skin.

  • 0

How to Clean the White Stuff on my Pool Tile

Tags : 

What is the white stuff on my pool and how does it appear?

The white or grayish deposit, also called calcium deposits, which is sometimes rough can appear on the liner of your swimming pool (on the bottom, the walls, and especially at the level of the waterline).

The formation of these deposits is because of two mineral salts naturally present in the water of your pool: calcium carbonates and magnesium. The more they are present in the water, the more they form lime residues on the walls.

You should know that from one region to another, the concentration of these mineral salts varies. This is a completely natural phenomenon that depends on the geology of the soil and the path of the water. Some pools are therefore more prone to the appearance of deposits than others.

How to measure the hardness of my swimming pool water?

The calcareous nature of water is defined by its hardness. On average, it is considered that the TH of the water in a swimming pool must be between 10 and 25 ° f (French degrees).

The tH corresponds to the hardness of the water, which indicates its concentration in limestone. It is measured in French degree (° F) and is ideal between 10 and 20 ° F. Indeed, the higher the tH, the harder the water is, that is to say, it is limestone. On the other hand, the lower it is, the softer the water.

Note: dedicated accessories allow you to easily calculate this hardness, such as connected water analysis devices, manual colorimetric testers (strips to be dipped in a water sample), or photometers.

What are the dangers of the white stuff?

Over time, lime deposits can build up. In excess, it can scale your equipment and pipes and therefore damage them or make them obsolete. It can also make the water cloudy, promote the development of algae, and irritate the sensitive skin of swimmers. So many inconveniences that can be avoided or combated.

Removing calcium deposits: the solutions

When the scale has settled, it is difficult to get rid of it. In fact, in the event of scaling, the water in the basin must be completely emptied and a descaling product used. The most powerful is to be left on. In all cases, you need a little elbow grease to rub the stains and remove them completely. Remember to remove debris after cleaning the basin.

If you cannot remove lime with a dedicated product and it damages your equipment, you may have to change it. A solution that often turns out to be expensive. Do not hesitate to seek the advice of a professional to note the damage.

Preventing calcium formation: the solutions

Prevention is better than cure! This is why it is advisable to adopt a preventive behavior by using an anti-limescale or anti-scale product.

This type of cleaning product is specially designed to prevent the formation of tartar. It is recommended to use them if the water is very hard. On the other hand, if the hardness of the water is not too high, no need to resort to it.

This type of product requires precautions for use. Read the instructions carefully. It mixes with the water in your pool, according to a precise dosage and with filtration on. On average, this treatment lasts 12 hours (during which the pool is unusable).

Besides applying an anti-limescale treatment for swimming pools, water heating should be controlled. Regular temperature monitoring limits the formation of lime. In fact, hot water tends to favor the formation of tartar. Likewise, regular maintenance and control of the quality of the water, in particular the TH and the pH, make it possible to avoid unpleasant surprises.

Do not hesitate to contact our experts for more information.


Calcium Gone

Call us when you want the calcium gonecalcium removal calcium killer

Tap Here to Call and speak to the expert in calcium.

pool tile cleaning,cleaning pool tile,Pool tile cleaner,swimming pool tile cleaning,cleaning calcium on pool tile,cleaning swimming pool tile,swimming pool calcium tile cleaning,cleaning white stuff on pool tile,white stuff on my pool tiles,calcium pool tile cleaning,cleaning calcium on my swimming pool tile,white stuff on my pool tiles,how to clean off calcium on my pool,calcium cleaning

Quick Contact Form

Your Name (required)

Your Phone # (required)

Your Email (required)

Subject

Your Message

Enter In these letters / numberscaptcha
In to this box to prove your real...

Swimming Pool Tile Cleaning | Calcium Cleaning | Cleaning Pool Tile Services - Just One Call To The Pool Tile Cleaner Pro Get's The White Stuff GONE!

Specialties Aquatic Tile Cleaning GPS Directions